Results 1 to 6 of 6

Thread: 2007 can-am renegade 800

  1. #1
    elkins3744 Guest

    Default 2007 can-am renegade 800

    is there an exhaust for this bike and if so are the exhausts dyno'ed????

  2. #2
    elkins3744 Guest

    Default Anyone there??????

    i am new and i dont know how long a reply takes. anyone know about a pipe for the renegade??????

  3. #3
    bschultz Guest

    Default

    We only offer a pipe for the Outlander at this time. The Renegade is on R&D's to do list, check back in a few months.

  4. #4
    Primemover Guest

    Default Renegade Exhaust

    I need to know if the Mudslinger Exhaust for the 800 Outlander will work on the Renegade. I already know this exhaust was not made for the gade. But can it be mounted to the Renegade? I have seen many other exhaust that will interchange between the Outi and the gade and work just fine because the same 800 motor is mounted in each none. Does anyone know?

  5. #5
    bschultz Guest

    Default

    You would most likely be better off Utilizing the MudSlinger Universal (P/N 136-8175). That way you could Custom fabricate the mounting system and connector pipe.

  6. #6
    ohiomotoxer Guest

    Default

    The Outlander uses a round cup type joint where the Renegade uses the traditional slip fit joint.
    BUT the 08's are supposed to be all slip joint type on Outlander/Renegades.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •