Fitting Supermeg from 2004 FLH to 2014 FLH

[kbiforce]

What is needed to fit this pipe to the 2014 FLH? The trans mounts appear to different. Looked at install sheets and it mentions p clamp and new trans mount. Have any part numbers for this? Thank you.

[bschultz]

The items mentioned in line #2, 4, 7 and Fig# 1 of the instructions are;
P/N 029-7578, mount bracket
P/N 014-1751, chrome P-Clamp
+ misc 5/16" hardware

Of course there is also the 12mm o2 bungs to be delt with.

[kbiforce]

Thank you for the part numbers. I even went back and relooked at the online instruction sheet and the only part number I see is for the exhaust gaskets. We must be looking at 2 different pages. I already welded in 18 mm bungs that I used with a Tmax on the last bike. I am looking forward to using this pipe on the new bike!

[bschultz]

We're not looking at different pages...the P/N's are not given, however they are mentioned/referred to...that's why you asked, correct?

[kbiforce]

You are correct! Thank you for the info.

[john.cipolletta]

oh... I used this advise too. Thank you!