Page 1 of 2 12 LastLast
Results 1 to 10 of 11

Thread: Kerker 128-71692 install

  1. #1
    Rhood Guest

    Default Kerker 128-71692 install

    Hello I have a 2013 dyna wide glide and I just bought the kerker supermeg 2-1 # 128-71692 as far as installation goes it look pretty forward to me. Is there anything I should know before installing these pipes are all the parts included ? any tricks I should know about ?

    Thanks

  2. #2
    bschultz Guest

    Default

    We recommend a fresh set of the "conical" style port gaskets.

    Start with one pipe (front OR rear) at the port and maneuver the other into place.

    Put system together loosely, then tighten.
    Last edited by bschultz; 11-04-2013 at 10:55 AM. Reason: additional info

  3. #3
    Rhood Guest

    Default

    Thanks any tricks to putting in the "conical" style port gaskets? also no disks on this setup. I want to be heared but not a mile away :-)
    Last edited by Rhood; 11-04-2013 at 11:09 AM.

  4. #4
    bschultz Guest

    Default

    Flat side toward the port ... tapered out towards pipe

  5. #5
    Rhood Guest

    Default

    Thanks for your help. I will post when done.

  6. #6
    Rhood Guest

    Default

    Do I need to get a tune after I put on the your exhaust system ?

  7. #7
    bschultz Guest

    Default

    If your closed loop fuel injection system is operating as intended, there shouldn't be a need.

  8. #8
    Rhood Guest

    Default

    Can't seem to find these pipes 128-71692 how long to order them ?

  9. #9
    bschultz Guest

    Default

    Next production run may be 6-8 weeks out.

  10. #10
    Rhood Guest

    Default

    Thanks I just order one !

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •