Identifying Exhaust Model

[bstig60]

I have an 88 Yamaha XT600. I think this is a 4 inch Aluminum Series with an open end cap. I can't find a model number stamped on it anywhere. I want to go with the closed end cap to make it a legal spark arrestor. I need to know what part number to order.
WP_000324.jpgWP_000325.jpg

[bschultz]

END CAP, 4", 6-BOLT,LETTERED,SS POLISHED 406-3046 $22.70

From the pic the discs look like they could be backwards? Be liberal with the anti-seize on the screws.

[bstig60]

Thanks, I will check the disks and will order the part. Can I use any type of anti seize grease on the bolts?

[bschultz]

Any good quality Hi-temp will work.

[bstig60]

I recently ordered the solid end cap for my 4 inch Supertrapp. I found when I went to install it, that I need the 120 degree deflector to keep the exhaust and heat off the rear fender and signal lite. I noticed the end cap and the deflector are offered as a package for a much smaller price that ordering them seperately... Since I already have bought the end cap, can I get the deflector to go with it at the reduced price???

Bill

[bschultz]

The 4" heat shield is a cosmetic piece (w/SuperTrapp logo) attached to the end of the disc assembly, NOT an "exhaust" shield.

[bstig60]

You are telling me there isn't a deflector available?????

[bschultz]

No; however the 120 or 360 degree exhaust shield is NOT sold as a combo unit with the end cap.

[bstig60]

I am looking for a deflector to deflect the exhaust off my rear fender. From the description, it would appear that is what the 120 degree "shield" is for. If not, what is available?

[bstig60]

No; however the 120 or 360 degree exhaust shield is NOT sold as a combo unit with the end cap.

Then what is this? END CAP + SHIELD, 4", ALUMINUM 402-3046 $28.90