SuperTrapp slip on's for 2007 FXDL

[RandyNew]

bschultz Can I use threaded 8/32 stainless steel rod as the 2 inch long 8/32 screws seem a little short when it comes to using 24 discs? I now have 22 and the ingagement is about a 1/4 inch or so. There is only like 1/8 of an inch to ingage into the threads in the baffle if I use the 24 and I would like the full thread which is close to a 1/4 inch it looks to be in the baffles. Where I get the 2 inch screws that is the longest they can get with out ordering a min., of 100 at a time. bschultz what do you think and thanks for your time? All ride safe now eh.

[bschultz]

The steel rod/nut combination seems like an alternative. Have you considered removing the disc assembly completly and running the core wide open?

[RandyNew]

So remove all the discs and only run with the baffles in and the end caps on? That will be pretty loud, wright? I have just tried with the end cap off idling and it sounds diff., and much louder. Thanks again bschultz.