Results 1 to 2 of 2

Thread: 1994 flhtcu with new motor

  1. #1
    sloridr Guest

    Post 1994 flhtcu with new motor

    I have what i see is a older bike compared to what i see in the forum, but here is the question. I just put in a ultima 100" motor and am running the stock muffler setup with supertrapp slipons. It seems to working ok but notice looked a little lean. I have not pulled them apart yet to count the discs i have. So while I do have it apart do you have any Idea how many I should start with? It is open end cap now.

    Also my brother also installed a new motor in his, same 100" ultima, but he is running a supermeg. He had it tuned for a 124" s&s motor which he pulled out. Should it run about the same, also he would like to make the bike a little quieter. If he adds the closed cap system what is the starting point he would use. He tried with the 124 and never could get it to run with the closed cap system on the supermeg 2 into 1 . Thanks sloridr

  2. #2
    bschultz Guest


    See response under "Installation".

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts