PDA

View Full Version : Fat shot discs



roadglide man
09-19-2009, 12:26 PM
My question is on the tightness of the discs. I believe the torque is 25 inch lbs. Or slightly snug. Is that critical to the flow through the discs. Or is it just a concern to not over tighten and strip or damage the pipe. I tightened them in the correct sequence but I did not torque. I may have over tightened them? Would this affect the performace of the pipe? PS this is a 4" screamin eagle Fat shot. Thx.

bschultz
09-21-2009, 09:26 AM
We recommend 15 inch pounds with applied anti-sieze. Yes, if you did tighten them down to much the self made spacers could be compromised; however 25 inch pounds should not be an issue, the stainless steel construction is pretty tough.