PDA

View Full Version : 2:1 Supermeg - Dyna Fat Bob - no P-Clamp



reesmicm
02-03-2009, 02:30 PM
Bob,
Installing my 2:1 supermeg 827-71574 and it calls for installation using the P-clamp under the timing cover. My factory pipes on my FXDF fat Bob does not have this P-Clamp. What do I do?:confused:

jwells
02-03-2009, 03:41 PM
I just sent you an email and spoke to your mechanic not more than ten minutes ago.
All the Dyna models except the Fat Bob utilize an exhaust support bracket that mounts to the bottom of the engine case. Our 2:1 utilizes this for additional support.
At this time, we would suggest getting one of these OEM brackets to fully support the exhaust system.

reesmicm
02-03-2009, 03:50 PM
Jeff,
I would think the factory system would have a lot more problems without this additional support due to the excessive weight of the factory systems verses the much lighter Supertrapp system. Would you agree?

jwells
02-04-2009, 10:22 AM
As I emailed you, it may be fine without the extra support, but we try to have the system mounted as securely as possible so as to be able to hold up to the most extreme abuse and can't suggest not using it.