PDA

View Full Version : SE Slipons



fatboy369
09-13-2007, 03:42 PM
I have SE slipon mufflers Harley part # 65115-98B the baffles are 23 1/4 in. long what Kerker baffle would work

hugger
09-13-2007, 04:42 PM
I have SE slipon mufflers Harley part # 65115-98B the baffles are 23 1/4 in. long what Kerker baffle would work

Hi there!

You can use the Kerker standard K3 baffle, part # 100-7580 sold as each or the Kerker Mukuni baffle part # 100-7857 sold as each.

Please note that the Kerker K3 baffle is close to the SE baffle as far as performance and a bit louder. The Kerker Mukuni baffle is going to give you more performance and it is very loud.

You can order both of these products thru your local friendly HD dealer.

Thanks for using SuperTrapp/Kerker products!!

fatboy369
09-14-2007, 12:46 PM
Are those 2 not to short, wont they burn my mufflers. the 7857 is only about 12 inches long, I heard that I should order 100-65115 and it would be a factory fit

bschultz
09-17-2007, 11:01 AM
Are those 2 not to short, wont they burn my mufflers. the 7857 is only about 12 inches long, I heard that I should order 100-65115 and it would be a factory fit

The K-3 Baffle is a full (body) length baffle. The Mikuni is a shorter "performance" baffle that may cause the front part of the muffler body to discolor if the machine is not tuned properly (excess heat from being to lean). The SE baffle (100-65115) is a direct replacement.

fatboy369
09-21-2007, 10:52 AM
Why is it that I am having trouble ordering a set of 100-65115 baffles, can I not just order from supertrapp or do i have to go to some dealer, which by the way is not going very well

Pumba11
04-29-2008, 02:21 PM
bschlutz,

I bought what I think are HD SE 65115-98B mufflers. Is this number stamped on them at all? I couldn't find any #'s.

Also, if I look through the right muffler I can see a little bit of light, but not a straight pipe through. The left muffler shows no light. Do you think I have 98B's.

Also, they are louder than I expected, can I just re-pack the baffles?

bschultz
04-30-2008, 07:59 AM
There is a P/N stamped on the muffler body that begins with 027-XXXX (4 digits). The SE baffles/cores are the same left and right and are not servicable (cannot be repacked). The whole core assembly can be replaced, an assembly similar to a cartridge.

Pumba11
05-27-2008, 03:03 PM
bschlutz,

I am back.

I located the number on the muffler it is 027-7117.

What muffler do I have?

I have found them to be too loud for distance riding since I can not re-pack it (I can see there is almost no packing left). Can I purchase quieter baffles to fit this muffer?

And back to this light issue from my earlier post, Gerry at your office think that they may have been modified and they should be the same (no light). Your thoughts?

bschultz
05-27-2008, 04:31 PM
These muffler bodies were used in HD Sreming Eagle slip-ons P/N 128-7115-98B for the '95-06 FLH/FLT models. They used the same core assembly as the 65115-98B's, which is the 100-65115.

Pumba11
05-27-2008, 04:52 PM
So do you think they were modified if I can see light through it?

Would new core's be at all quieter?

bschultz
05-28-2008, 08:08 AM
Yes & yes.

Pumba11
05-28-2008, 09:42 AM
Okay, I think its the last set of questions.

- Just to verify, light means modified correct?

- If I were to swap left and right baffles would that make a difference? (since the left is not modified) Or, effect performance?

- What is the cost shipped of the replacement baffle?

Boy, I am such a pain in the.... ;-)

bschultz
05-28-2008, 11:27 AM
They were either modified or replaced with another Kerker core. Have you pulled the core assembly out of the body? If they are a replacement core they may be servicable.

Pumba11
05-28-2008, 02:07 PM
I will pull them tonight. Will I find a part number on them?

bschultz
05-28-2008, 02:34 PM
No part number.
Contact Customer Service for pricing and we will need an address for a shipping estimate.

Pumba11
06-02-2008, 10:49 AM
RAVE

Gerry in cutomer service suggested that the right baffle was punched out by the previous owner. I thought she was goofy...that couldn't be it!

Well, after pulling the muffs off the bike and getting out the high power flashlight, she was absolutly right!!!!

Listen to these people here a SuperTrapp, they know their stuff!