PDA

View Full Version : Kerker 128-71692 install



Rhood
11-04-2013, 07:54 AM
Hello I have a 2013 dyna wide glide and I just bought the kerker supermeg 2-1 # 128-71692 as far as installation goes it look pretty forward to me. Is there anything I should know before installing these pipes are all the parts included ? any tricks I should know about ?

Thanks

bschultz
11-04-2013, 10:52 AM
We recommend a fresh set of the "conical" style port gaskets.

Start with one pipe (front OR rear) at the port and maneuver the other into place.

Put system together loosely, then tighten.

Rhood
11-04-2013, 11:06 AM
Thanks any tricks to putting in the "conical" style port gaskets? also no disks on this setup. I want to be heared but not a mile away :-)

bschultz
11-04-2013, 01:33 PM
Flat side toward the port ... tapered out towards pipe

Rhood
11-04-2013, 02:16 PM
Thanks for your help. I will post when done.

Rhood
11-04-2013, 08:08 PM
Do I need to get a tune after I put on the your exhaust system ?

bschultz
11-06-2013, 07:15 AM
If your closed loop fuel injection system is operating as intended, there shouldn't be a need.

Rhood
11-12-2013, 04:01 PM
Can't seem to find these pipes 128-71692 how long to order them ?

bschultz
11-13-2013, 07:18 AM
Next production run may be 6-8 weeks out.

Rhood
11-13-2013, 11:52 AM
Thanks I just order one !

Rhood
11-19-2013, 10:45 AM
Can you check on my order from Trends 15594177


Thanks I just order one !