PDA

View Full Version : Need parts for installation



STclueless
08-11-2008, 10:31 AM
Hello,

I bought a used Supertrapp Supermeg 2 into 1 for my 2002 HD Dyna (model 828-71454). The system did not come with the mounting bracket that is listed on the online instructions. Is it possible to by the bracket and associated hardware from Supertrapp directly?

I also measured the discs at roughly 3 3/4" diameter, I'm assuming this means the 4" discs are the correct discs if I want to add more? also the one bolt holding the discs on appears to be a special torx screw, where do I get a tool to remove that bolt?

thanks,
clueless

bschultz
08-12-2008, 07:01 AM
Contact Customer Service with part numbers from the muffler body and headpipe. The system you purchased may "look" like model 828-71454: however the only place we use "security" screws are on OEM systems.

STclueless
08-14-2008, 06:11 AM
When your saying OEM, could it be a Harley SE exhaust system? The number on the muffler is 027-7492 and the number on the header is 050-7492.

Would the discs be the same as the actual Supertrapp systems?

bschultz
08-14-2008, 07:06 AM
The part numbers referenced are components from system P/N 878-71490, a 2:1, 300 wide tire system we made for Thunder Mountain. This system uses 4" discs.