PDA

View Full Version : 2007 can-am renegade 800



elkins3744
01-16-2008, 08:58 PM
is there an exhaust for this bike and if so are the exhausts dyno'ed????

elkins3744
01-17-2008, 12:26 AM
i am new and i dont know how long a reply takes. anyone know about a pipe for the renegade??????

bschultz
01-17-2008, 07:08 AM
We only offer a pipe for the Outlander at this time. The Renegade is on R&D's to do list, check back in a few months.

Primemover
03-26-2008, 09:40 PM
I need to know if the Mudslinger Exhaust for the 800 Outlander will work on the Renegade. I already know this exhaust was not made for the gade. But can it be mounted to the Renegade? I have seen many other exhaust that will interchange between the Outi and the gade and work just fine because the same 800 motor is mounted in each none. Does anyone know?

bschultz
03-27-2008, 07:03 AM
You would most likely be better off Utilizing the MudSlinger Universal (P/N 136-8175). That way you could Custom fabricate the mounting system and connector pipe.

ohiomotoxer
03-27-2008, 10:34 PM
The Outlander uses a round cup type joint where the Renegade uses the traditional slip fit joint.
BUT the 08's are supposed to be all slip joint type on Outlander/Renegades.